1. Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Boom's Recent Activity

  1. Boom liked msell66's post in the thread Oil Sending Unit Leak/Spray.

    I was just getting ready to type that same thing. No, really!

    Jan 21, 2018 at 5:15 PM
  2. Boom replied to the thread Oil Sending Unit Leak/Spray.

    Might be worth getting a brass extension, swear I've seen em. That and a thin layer of teflon tape. Should seal up and the brass will...

    Jan 21, 2018 at 5:13 PM
  3. Boom replied to the thread Oil Sending Unit Leak/Spray.

    So it's coming out of the bottom of the sending unit itself? My bad, I misread what you said. Thought you said it wasn't coming out of...

    Jan 21, 2018 at 4:57 PM
  4. Boom replied to the thread Oil Sending Unit Leak/Spray.

    So its leaking from the block? Is the area clean? Check to make sure there are no cracks. Maybe run a tap through the hole to clean...

    Jan 21, 2018 at 4:49 PM
  5. Boom posted a new thread.

    New Toy! SR9

    Picked up a new pistol off a buddy this afternoon. I got a Ruger SR9. Fires nicely. I went to the range with a few friends and we...

    Forum: Politics, Guns, and a can of Whoop Ass!

    Jan 21, 2018 at 4:43 PM
  6. Boom replied to the thread Blu '67 coupe project is back on!.

    What's your plan for the front end? I would consider the MTF full subframe if my car was in the condition. Pricey, bu you could drop...

    Jan 20, 2018 at 5:45 PM
  7. Boom replied to the thread It's that time again...name that car!.

    Says Plymouth on the dash it looks like.

    Jan 20, 2018 at 5:41 PM
  8. Boom replied to the thread Boom's 68 fastback.

    Thanks! I didn't want to have to modify the harness and that was just an empty area so I figured it'd be a good spot. I got my air...

    Jan 20, 2018 at 2:16 PM
  9. Boom replied to the thread Boom's 68 fastback.

    See the third picture with the "CHINA" letters, that's the water fitting I'm currently using. I Just waiting on the air cleaner and...

    Jan 18, 2018 at 4:38 PM
  10. Boom replied to the thread Boom's 68 fastback.

    Thanks for the suggestion Jim! I'll see if I can't check that Monte carol bar out. I sold my MSD distributor (sadly, I liked it but...

    Jan 18, 2018 at 3:53 PM
  11. Boom replied to the thread I think I just found my WE Gift for Duane.

    It's fun to play in the dark... Found it on Hebay:...

    Jan 15, 2018
  12. Boom replied to the thread Snow Plow took out my mailbox.

    Watch, you'll get a bill from the county for damaging their truck. Then you'll get a late fee since the PO can't deliver it since you...

    Jan 15, 2018