• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

1/3 scale ardun motor

These guys are amazing machinists. Even more amazing that they are not using cnc machines. I am a pathetic hacker compared to those guys. I have been working on a small two cylinder stirling engine model for a while. Here are some pics of the block and cylinder head. I was putting a engine turned or jewelled finish on the block with cratex points on the sherline micro mill. There is also a shot after turning the ribs on the cylinder.
46fb510d-a3ed-639c.jpg
46fb510d-a3ff-ff8f.jpg
 
You must log in or register to reply here.
Back
Top