PraireBronze
Member
Does the gasket between the rear end housing and the 3rd member go in dry? Or does it need a sealant? Recommendations would be appreciated.
-
Hello there guest and Welcome to The #1 Classic Mustang forum!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
Rear axle question
- Thread starter PraireBronze
- Start date
Sluggo
Active Member
I put mine in dry.
I'll bet that hurt a bit... :sm_TMI"Sluggo" said:
MD69Boss
Suspected Troll
"Sluggo" said:
Dry here too, and use the crush washers when assembling, available through either NPD, or I believe AMK...
HTH
Dry? Wow! Sheep can't like that.
A
Anonymous
Guest
I don't use the paper gasket, just sealer. No leaks after 2 gear changes.
janschutz
Corn Hauler
+1"silverblueBP" said:
66gt350
Active Member
"silverblueBP" said:
Ditto here. Not a leak. now if I can only say the same about the rear main seal....