A wooden or aluminum baseball bat? Your extensive experience and insight is needed.
-
Hello there guest and Welcome to The #1 Classic Mustang forum!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
Which type is better?
- Thread starter Midlife
- Start date
70_Fastback
Hell Bent for Speed
I think Dave will require further supporting information. For instance: Wood type; is it composite? If not, was it cut down by under skilled Asian laborers that were previously fired by Mark?
What grade of Aluminum? What is the copper content of said aluminum? Is it made from recycled Pabst Blue Ribbon cans - or Guinness Draught cans?
What grade of Aluminum? What is the copper content of said aluminum? Is it made from recycled Pabst Blue Ribbon cans - or Guinness Draught cans?
daveSanborn
Active Member
Definitely aluminum! The "sweet spot" on an aluminum bat runs most of it's length.
Also, if you drill a vent hole in each end of the bat.... it can be thrown of the next bridge you drive over and it will sink.
This one was a no-brainer.
Also, if you drill a vent hole in each end of the bat.... it can be thrown of the next bridge you drive over and it will sink.
This one was a no-brainer.
Fast68back
Guest
"daveSanborn" said:
It kinda scares me that you know that.....
daveSanborn
Active Member
Yeah, it's been a few years now since I learned that wood floats and metal doesn't. I think I read it in a book or something.
AzPete
Well-Known Member
"daveSanborn" said:
Or something sounds more like it....
daveSanborn
Active Member
Dammit.... I walked right into that one....