-
Hello there guest and Welcome to The #1 Classic Mustang forum!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
66 mustang 8 inch rear axle housing
- Thread starter GT350
- Start date
AzPete
Well-Known Member
I believe it will be 2" narrower than the '67 housing. It would be good depending on what backspacing you want on your wheels. Not sure but I think the mounts are located the same.
AtlantaSteve
Active Member
Yep, Pete's right. I have a 67 rear axle in my 66...pushed my tires out 1 inch on each side. Which is fine, because I'm using wheels that normally require 1" adapters on each side.
Steve
Steve
guruatbol
Always on vacation!
That is good to know. I want to get a different chunk in the 67, maybe I'll get the 66 and then bury some wider meat under it.....Hum....
Mel
Mel