Can someone show me 65 fastback trunk wiring routing?

[Coupe]

I am finally ready to install my new rear harness and I cannot remember how it ran, I kinda see how but where does the sending unit wire take a different path? Does it go in front of the trap door bracing and down to the tank edge or does it run from the wheel house to the hole in the trunk pan?

Also, whats this hole for? (Screwdriver is pointing at it).

 

[Midlife]

The fuel sending line comes out on top and over over the wheel well through some of the sheet metal structure (but behind the vertical panel or towards the rear valence), across the back edge where the tank sits (there's a p-clamp to hold it in place), and enters the hole on the drop-off trunk for the grommet. There's a piece of tape to keep it in place on the rear deck area, IIRC.

I've no idea about that hole...it wasn't in my 66.

 

[cmayna]

As far as I know that hole in question is not the norm.

 

[Coupe]

As far as I know that hole in question is not the norm.

Great, I guess I shoulda asked before all of the paint/primer. Welding it shut now would make a mess, seam sealer it is!