• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Carb setup info

B67FSTB

The NorCal dude from Belgium
So , I had bought a 351W engine in the past and meanwhile I made a teststand to runtest the engine.

The engine has a ACCELL distributor and the cap sits high so I have to rise the carb with a 1/2 spacer. So far so good.

What do I have : edelbrock 2181 intake which is a 4-bbl Square-Bore Carb Flange.
edelbrock 1405 600cfm carb

My questions : Can I use this kind of spacer ? I have a phenolic one ?

how does the upper and lower seals look like ? Thx !
5020336_edb_8713_pri_larg.jpg
 
that looks tall. With the extra height of the 351W, you do not have much clearance for the air cleaner. I only have about 3/8" of clearance left on mine setup.
 
Thats an example. Its a 1/2 spacer with the 4 holes.
And the engine is on a teststand but it should work in a 67 engine bay.
Just wondering which gaskets to use beneath and above the spacer.
 
Back
Top