• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

distribution block

I'm on a airplane right now. Otherwise I'd send you a pic right now. If no one has by the time I get home.......


TapaYakin' from my iPhone
 
Finally got off my butt and took a pic of Red's distribution block. Note the black adjustable proportional valve which is seperate.

I'm sure there are other distribution blocks that would work as well for your application Doug.


4-270712060021-101901589.jpeg



4-270712060023-101951953.jpeg
 
Last edited by a moderator:
But now that I have googled a '69 distribution block, my pics above apparently do not reflect a typical '69 set up. Here's a pic of what I found.

T2eC16Vy8E9s2fjt4BPKTG1d60_57.jpg
 
Last edited by a moderator:
"cmayna" said:
But now that I have googled a '69 distribution block, my pics above apparently do not reflect a typical '69 set up. Here's a pic of what I found.

T2eC16Vy8E9s2fjt4BPKTG1d60_57.jpg
Click to expand...

I have this distribution block but im missing the piece on the angled bend. (internal proportioning valve) Havent found anywheres to buy them either
 
Last edited by a moderator:
Couldn't you just install a SSBC adj proportioning valve in it's place? If so, try NPD# 2B091-1A
 
"cmayna" said:
Couldn't you just install a SSBC adj proportioning valve in it's place? If so, try NPD# 2B091-1A
Click to expand...

thats what its looking like ill have to do, was trying to stay away from that just so I didnt have to create my own lines and make it all work.
 
You must log in or register to reply here.
Back
Top