• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Is this the right collector reducer I need?

S

sigtauenus

Active Member
427_03_04_10_8_05_30_1.jpg


You can see the collector fitting I have. Its a 3 bolt movable bracket and there is a lip on the end of the header.

http://www.summitracing.com/parts/PYE-PVR16S/

This looks like it might fit, but I don't know if it would seal against my collector.

Suggestions?
 
If you don't need stainless, I think that I have a couple of those type collectors floating around in the shop. Yours for the price of shipping. What diameter do you need?
 
Rob, thanks for the offer. I'm mating up ceramic coated headers and the Magnaflow stainless exhaust. Pre-fab'd, these Pypes brand are the only stainless collector reducers I've found that go from 3.0 to 2.5".
 
Awesome, thanks!

I swear I did the sort there using stainless and all that came up were the Pypes brand pieces.
 
You must log in or register to reply here.
Back
Top