pinion bearing yolk ford rear help needed

[GT350]

im in the process of sorting out the 9 inch rear for my 69 mustang,the centre section i took out of it is goosed.
i have a good traction-lok unit but the pinion yolk was used for another car.my question is can i swap the yolk for my existing rear onto the traction-lok and whats the best method would i need to replace crush sleeve ? thanks in advance

 

[mustangstofear]

Hi Javed. Your yolk will work on your new rear end. You will need to take it and have your machinist pre load your pinion bearing, some use shims and others use crush sleeves. Rich.

 

[GT350]

Hi Javed. Your yolk will work on your new rear end. You will need to take it and have your machinist pre load your pinion bearing, some use shims and others use crush sleeves. Rich.

thanks rich

 

[jmlay]

Very easy! If it were me I would replace the bearings while I had it apart. Make sure you do no damage the o-ring & you will need to set the pinion depth after.

http://www.ford-trucks.com/article/idx/9/065/article/Ford_9_Inch_RebuildGear_Setup.html

Mike