• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Stick on badges?

T

Tungsten

Member
Does anyone make original looking badges that are stick on for my 65 289? I'd rather not drill the holes in all my new sheet metal.
Thanks!
-Jeff
 
Just cut the pins off of the back of the emblem and use 3M emblem glue (clear).
 
"Midlife" said:
Just cut the pins off of the back of the emblem and use 3M emblem glue (clear).
Click to expand...

I'm surprised that you didn't suggest using duct tape and baling wire!! :craz
 
"Tungsten" said:
Thats what I plan on doing, but it's not that easy. The badges are not flat on the backside.
Click to expand...

So...even if you kept the pins, you're saying that the badge won't sit flush against the metal? What is this badge you speak of?
 
Any type of light weight filler would most likely work. Sounds like it would be just as easy to drill the holes...
 
The emblem glue will work on the edges just fine. The glue is clear and very hard to see. You apply the glue to the emblem and press into place. Just use masking tape to keep it there until it dries (a few minutes at most).
 
Laurel Mountain Mustang has them available with double sided tape already applied. I was looking at them in the show room the other day.
 
You must log in or register to reply here.
Back
Top