I thought I'd share a few photos of the exhaust going into my '69 Mach.
This has been a bit of a story. I had full intention of using the factory set up, but I had upgraded my heads to Edelbrock Performer RPMs, and my mechanic friend shook his head about the lack of headers. It was a long time shopping and I actually had a few different sets tried out for fit. In the end, some Headmans were selected and the rest of the system way built. You will see some tips in the photos. These were put on for the photo, but are not the tips being used. I am also looking into the potential advantage of rounding out the corners on the H pipe by cutting and grafting in some smoother curves. This is the fit so far..
This has been a bit of a story. I had full intention of using the factory set up, but I had upgraded my heads to Edelbrock Performer RPMs, and my mechanic friend shook his head about the lack of headers. It was a long time shopping and I actually had a few different sets tried out for fit. In the end, some Headmans were selected and the rest of the system way built. You will see some tips in the photos. These were put on for the photo, but are not the tips being used. I am also looking into the potential advantage of rounding out the corners on the H pipe by cutting and grafting in some smoother curves. This is the fit so far..
