I need to lower the fuel level in a Autolite 4100 carb. Instructions says to "bend the float tab (contacting the fuel inlet valve), downward to lower the level. My question is where specifically do I bend it? When they say tab is it the Tab I marked as A ?
Ahhhhh.....I just looked at the bottom side of the horn and there is extra material telling me that the upper horizontal edge of the tab (A) must make contact with. Thus if I bend this tab downward, it will drop the fuel level a tad?
Ahhhhh.....I just looked at the bottom side of the horn and there is extra material telling me that the upper horizontal edge of the tab (A) must make contact with. Thus if I bend this tab downward, it will drop the fuel level a tad?
Last edited by a moderator: