EFI fuel lines

[RapidRabbit]

I need to start looking at running my fuel lines for the EFI motor I am installing.

What suggestions does anyone have?
Should I bend metal lines, run braided lines or high pressure rubber lines?
Anyone pics of routing would be appreciated too.

Thanks
Pat

 

[66gt350]

I'm using metal lines down the passenger side subframe, and then took them to the center of the car over the pumpkin. Initially, I installed aluminum fuel line, easier to bend. But I've got a couple rolls of stainless steel 3/8" out in the shop when I get ambitious. So far, I've had no problems with the aluminum. I've got them tightly secured to the car to prevent any movement.

Here's a couple shots that I've taken a long time ago, when I installed them. I can try and get under the car tomorrow night for some better pics.