• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Are you kidding me?!

Ground wire on the left attached between the apron & solenoid goes down and attaches to font of engine block.
ground.jpg


And here's the battery in the trunk.
battery.jpg


So remove the ground from engine block and put it on frame rail? I have it connected like it was when I bought the car and I never had any issues starting or turning off then so figured if it worked and that's how it was, put it back that way. :shrug
 
Last edited by a moderator:
:wth... No remove the grounding point from behind the sol at the apron and bolt it to the frame rail.
It will give a better ground for the eng block and besides looking better may keep the sol from sticking and not allowing you to turn it off with the key.
 
You must log in or register to reply here.
Back
Top