• Hello there guest and Welcome to The #1 Classic Mustang forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

miss me??

picked up some equipment yesterday & a new compressor today. now if i just had some electricity to run the stuff.... jonk67 & fordrule stopped by today to check everything out. enjoyed the quick get together :thu

new mill/drill combo. picked this up with a small scratch on the stand. $2400 package & got it for $1200 :bowdown:
IMG_2628.jpg


new belt/disc sander;
IMG_2629.jpg


band saw;
IMG_2631.jpg


also picked up this hydraulic lift table. it paid for itself already just getting the mill off the trailer. i figure when its not in use loading/unloading, it will make a nice worktable. it weighs about 300lbs, has an 1100 lb capacity & lifts to 38". the top is 31"x63" & is almost 1/8" thick steel.. i need to clean it up a bit as it was new in the box, but left outside until the cardboard disintegrated around it. i dont have any problem cleaning it up for the $400 discount i got :yah
IMG_2632.jpg


new compressor 7.5hp 80 gal 2 stage:
IMG_2634.jpg


new dayton tubeaxial paintbooth fan. pretty enought to be on a car!!
IMG_2633.jpg
 
Last edited by a moderator:
Glad fordrule and I caught you at home before you turned in, looked like you had done your days work but it was a good visit. Too bad we couldn't have been there when you were unloading some of that stuff. Don't forget I've got your hoist, would it help to lift that mill off the flatbed? I can bring it by if so. I can swing by and help you lift it off or move stuff on the weekend or Mon/Fri. night, I have school T,W,Th. evening.

I hope Joey or I can help you with wiring, etc., don't hesitate to ask. I really like that floor.
Jon
 
Glad to meet both of you. I might be having a short day on Friday if you need a hand. Also I don't have plans so far for sat. I know on Sunday jonk67 and myself are going to tarafied1 to work on rhe stangfix dragcar. Send me a text and let me know.
 
thanks for the help today!! for the rest of you, we started out early putting a puzzle together & ended up with a new blast cabinet when we were finished. :yah

IMG_2653.jpg

IMG_2654.jpg


after a trip to home depot, we finished the walkway that goes from end to end in the attic & layed down one section of decking for storage.

IMG_2651.jpg

IMG_2652.jpg
 
and no one fell through the siding balancing to get everything screwed in...lol it was fun being "old"spider monkeys..
 
You must log in or register to reply here.
Back
Top