Mach1 Driver
Well-Known Member
Since my Mach is so nose heavy and my lift has short arms**, I am going to use the pinchweld in the rear to support the car. I've read that some people use the bottom edge of the weld to support and others use the flat areas on either side.
Since the edge of the weld is uneven and often has just one metal thickness sticking below the other, I can't see why anyone would try to use that surface.
What have you done?
** Its the tyrannosaurus of two post lifts
Since the edge of the weld is uneven and often has just one metal thickness sticking below the other, I can't see why anyone would try to use that surface.
What have you done?
** Its the tyrannosaurus of two post lifts